Please note: If you plan to use a Multi-hop setup please see this guide and make the required adjustments to the port in the Endpoint Address & public key in the Peer Public Key fields.Are you looking to install a VPN on your DD-WRT router? In this guide, we will walk you through the steps to set up a VPN on your router using DD-WRT firmware. Reboot your router and wait for a minute or two for everything to settle, then reboot your computer system.Ĭheck the assigned public IP address on our website and run a leak test at from one of the devices connected to your DD-WRT router. Specify one of the following DNS servers in the Static DNS 1 field: The Endpoint Address and Peer Public Key in the example above are specific to our server in Sweden.Ĭlick the Save button, then click the Apply Settings button.
Note: You are welcome to use whichever server you prefer. Peer Public Key: Enter an IVPN WireGuard server public key (available on the Server Status page).Endpoint Address: Enter an IVPN WireGuard server hostname (available on the Server Status page) and choose a port:.10.0.254.3 = AntiTracker Hardcore Mode to also block Google and Facebook.10.0.254.2 = standard AntiTracker to block advertising and malware domains.172.16.0.1 = redular DNS with no blocking.Peer Tunnel DNS: Specify one of the following DNS servers:.This will prevent out-bound traffic when the VPN client is disconnected from the server.Ĭlick the Add Peer button and enter the following peer configuration (as also shown in the screen shot below): This will display details of the WireGuard connection including the public key, which can be easily copied.
Click the Save and Apply Settings buttons, then go to Administration > Commands and enter wg in the Commands box, then click Run Commands. Hint: After clicking Generate Key, it may or may not be possible to copy the public key displayed on the Tunnels page.
0 kommentar(er)
